Subject: naming a CG Hi, Could you tell me the procedure for naming an uncharacterised CG? Were working on CG17009 and have shown that it encodes a Borealin-like protein, we term Australin. We are reporting this at the Drosophila cell cycle meeting in Porto this June, and currently have an abstract in that booklet. However, we'll not submit a paper until later in the year, and would like to get the gene name out to the community. Thanks in advance for your help James ps \- we would suggest "aus" for the gene name, but I noticed another uncharacterised locus with that name. Does this matter? If so, might "aust" be acceptable? James Wakefield Department of Zoology University of Oxford Oxford, UK OX1 3PS Subject: Re: naming a CG Dear James, Thank you for your enquiry. aust would be a fine gene symbol for your gene, with the full name being 'australin'. Capitalisation is important (symbol and name should have the same case of initial letter). Aus is indeed already in use for FBgn0042093, and since we discourage the introduction of gene symbols/names that differ only in case I would advise against aus, as it would inevitably be confused with Aus. If you like I can curate your email as a personal communication to FlyBase which will establish aus:australin as the symbol:name for CG17009. Although we are working towards an update of FlyBase information it is not likely to become public until August, well after you present your results in Porto. Hope this is helpful, Best regards, Rachel. Subject: Re: naming a CG Hi Rachel, Thanks for getting back so quickly. Sure, please curate the e-mail. We'll make sure we use aust and australin for the talk in Porto. best wishes James